Join Date: Jan 2019
Location: Toowoomba, QLD, AU
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 110 Post(s)
Decat - Pro Fusion/Dominator owners
Ran into issues aligning the Pro Fusion decat i purchased some time ago.
Fully seating the stock can, the mounting tabs for both the can and the heat shield mounting tab are off by at least a full inch.
I could cut that amount from the end of the link pipe but even the link pipe mounting tab places some stress on the headers by pulling on them (only have the outside bolts loosely fitted).
Can anybody confirm if the Dominator decat is a solid fit?
At this stage i'll look for a refund from Oli Jones and will either purchase the Dominator decat or Arrow/Yoshi headers.
Thanks in advance.
When life throws you curves, lean into them.