GSXS 1000 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Hi,

What have you guys done with the exhaus gasket when you change the headers? Is there any gasket on the stock exhaust?
Im about to change on mine, but can not see the stock gaskets.

Need some advice here:D
 

·
Registered
Joined
·
233 Posts
do you mean the exhaust manifold gaskets? the original gaskets are made of copper and a bit difficult to remove without deforming them. when I bought the black widow exhaust manifolds inside the box there was also a set of bigger new gaskets.
 

·
Registered
Joined
·
244 Posts
hi, they come out easilly with a screwdriver that has approx 3mm bent tip @ 45 degree, , best to replace them due to the involved nature of installing replacement exhaust, regards craig, (ex m/cycle technician)
 

·
Registered
Joined
·
14 Posts
Discussion Starter #4
Jes, i see there is something copper ish inside the exhaust manifold. I will then try to remove them, but was not sure that there was any gasket on the orignal, due to the was stuck as H***.
But going to try with a screwdriver today.

Thanks Guys
 
1 - 4 of 4 Posts
Top