Hey guys,
Just installed my generic everyday fender eliminator on my new 2016 GSXS 1000. I noticed that there's 2 holes in the undertail where the plate mounts up that exist after you remove the old fairing. I was wondering what you guys are doing to close these holes so that no water goes up into the storage compartment. One of the holes I ran the turn signal and plate light wire thru. Any help on how to close these holes would be greatly appreciated.
Thank you!
Just installed my generic everyday fender eliminator on my new 2016 GSXS 1000. I noticed that there's 2 holes in the undertail where the plate mounts up that exist after you remove the old fairing. I was wondering what you guys are doing to close these holes so that no water goes up into the storage compartment. One of the holes I ran the turn signal and plate light wire thru. Any help on how to close these holes would be greatly appreciated.
Thank you!
