GSXS 1000 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
309 Posts
Discussion Starter #1
I need to remove the right side body panel on my F model. But to do so requires that the large electrical connector block located under the right side meter panel be unplugged.

So far I haven't been able to figure out the trick to get it done and I don't want to screw anything up.

The service manual basically just says "unplug it".

Any advice would be greatly appreciated.
 

·
Registered
Joined
·
102 Posts
If you look at the end of the connector block on the engine side you will see 2 "edges" that help with pulling the connector apart. There is also a small tab on one of the other sides of the block (still engine side) and this needs to be pulled outwards while pulling the connector apart. Mine took a bit of wiggling! Hope this makes sense as it's easy once you know but difficult to describe. All the best
 

·
Registered
Joined
·
102 Posts
Glad to have been of some help Rusty. I got a bit of a headache when I first took my fairing off but it gets easier each time !!
 
1 - 5 of 5 Posts
Top