GSXS 1000 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,250 Posts
The PDFs say that "Manufacturers torque specification" should be applied. Which I believe is 55N-m (40.5 lbf/ft) for frame sliders and 10Nm /7.5 lbf-ft for clutch and stator covers but you should check for yourself.
 

·
Registered
Joined
·
4 Posts
Man!! Thank you for posting what you've found. I was installing the complete kit and they didn't send instructions for the puck installation I was going over the bike trying to figure out where that short spacer went. Wow, thanks so much! Good vibes your way.
 
1 - 4 of 4 Posts
Top