GSXS 1000 Forum banner
1 - 13 of 13 Posts

· Registered
Joined
·
649 Posts
Well the strip down went ok until I tried to remove rear bearings.
There is very little play on the axle sleeve so my trusty bearing drift will not fit.
Ordered a new set of drifts so fingers crossed.
 

· Registered
Joined
·
649 Posts
Wheels are ready to be picked up from the powder coaters, just need to find some time to get down there and pick them up.
As an FYI the bearing sizes are Front, 22x44x12 and Rear 28x52x12
I got my bearings from Bearings: Ball Bearing, Needle Roller, Linear & Thrust Bearings and I got the rubber seal bearings and will remove one of the seals when fitting.
Also received in the post, Carbon fibre swingarm protector and bar end mirrors, so it's all taking shape now.
 

· Registered
Joined
·
649 Posts
Wheels are ready to be picked up from powder coaters, new Koyo bearings have arrived 22x44x12 front and 28x52x12 rear if anyone is wondering.
Parts awaiting fitting now consists of carbon fibre swingarm protector, levers, bar end mirrors and the plastics with a different colour scheme.
 
1 - 13 of 13 Posts
Top